Review

1. Hypersonic starting flow at high angle of attack
2. Advances and trends in plastic forming technologies for welded tubes

Fluid Mechanics and Flight Mechanics

1. Instability and sensitivity analysis of flows using OpenFOAM®
2. Numerical simulations of high enthalpy flows around entry bodies
3. Modeling and simulation of a time-varying inertia aircraft in aerial refueling
4. Experimental investigations for parametric effects of dual synthetic jets on delaying stall of a thick airfoil
5. Experiments on unsteady vortex flowfield of typical rotor airfoils under dynamic stall conditions
6. Experimental study on combustion characteristics of Chinese RP-3 kerosene
7. Precessing motion in stratified radial swirl flow

Solid Mechanics and Vehicle Conceptual Design

1. Containment ability and groove depth design of U type protection ring
2. Crashworthiness analysis of aircraft fuselage with sine-wave beam structure
3. Static strength analysis of dragonfly inspired wings for biomimetic micro aerial vehicles

Electronics and Control

1. A new SINS/GPS sensor fusion scheme for UAV localization problem using nonlinear SVSF with covariance derivation and an adaptive boundary layer
2. Obstacle avoidance for multi-missile network via distributed coordination algorithm
3. Modeling and simulation of bow wave effect in probe and drogue aerial refueling
4. A novel two-stage extended Kalman filter algorithm for reaction flywheels fault estimation
5. SNR periodical variation of Chang’E-3 spacecraft orbiting the Moon
6. Relative dynamics estimation of non-cooperative spacecraft with unknown orbit elements and inertial tensor
7. A novel range-Doppler imaging algorithm with OFDM radar
8. Haze removal for UAV reconnaissance images using layered scattering model
9. Empirical analysis of airport network and critical airports

Material Engineering and Mechanical Manufacturing

1. Nanoparticle type effects on flexural,interfacial and vibration properties of GFRE composites
2. Convex shaping process simulation during counter-rotating electrochemical machining by using the finite element method
3. Quasi-static tensile behavior of large-diameter thin-walled Ti–6Al–4V tubes at elevated temperature
4. Improvement and application of Y2O3directional solidification crucible
5. Machining of a film-cooling hole in a single-crystal superalloy by high-speed electrochemical discharge drilling