Current status of technique for Billroth-l anastomosis in totally laparoscopic distal gastrectomy for gastric cancer

Shun Zhang,Tetsu Fukunaga

1Department of Gastroenterology and Minimally Invasive Surgery,Juntendo University Hospital,Tokyo 113-8421,Japan.

2Department of Gastroenterology Surgery,Shanghai East Hospital,Shanghai 200120,China.

Abstract

Keywords. Billroth-I anastomosis,totally laparoscopic distal gastrectomy,gastric cancer

INTRODUCTION

In 1994,Kitano firstly reported the technique for laparoscopy assisted Billroth-I (B-I)[1].Since then,the use of laparoscopic treatments for gastric cancer is increasing due to the advantages of improving patients' quality of life.The new technologies and improved techniques have allowed laparoscopy gastrectomy to expand its indications and also to use this treatment for more complex cases.Japan Society of Endoscopic Surgery (JSES) conducted national survey every 2 years and indicated the percentage of laparoscopic procedures for gastric cancer was increasing.According to the 12th JSES survey,laparoscopic distal gastrectomy (LDG) was the most commonly performed type of laparoscopic gastrectomy[2].

In initial series for LDG,the majority of anastomoses were performed by laparoscopy assisted procedures.The assisted procedures needed a mini-laparotomy incision of 60-70 mm in length made on the epigastrium[3].But this procedure was not always easy to do,especially on patients with a small remnant stomach or obese patients with thick abdominal walls[4].Anastomosis in such restricted space was usually difficult.With the accumulation of laparoscopic surgery experience and the development of laparoscopic devices,the gastrointestinal reconstruction now can be completed laparoscopically.Furthermore,unnecessary manipulations and the incision made on the epigastrium can be avoided.

The ideal reconstruction should be not only for doctors but also for patients.Alimentary intake,satisfactory nutritional status and easy performing should be all considered[5].The B-I anastomosis is preferred by many doctors.It is said that the B-I anastomosis is simple and can provide a physiological route for food digestion and absorb without the need for an intestinal bypass or blind loop.Until now,various intracorporeal B-I anastomosis techniques were reported.In this article,we will review theses reconstruction methods.

HAND-SEWN ANASTOMOSIS IN INTRACORPOREAL B-I RECONSTRUCTION

After the accumulation of operative experience,some experienced surgeons had also presented intracorporeal hand-sewn techniques.

Takiguchiet al.[6]firstly reported B-I intracorporeal hand-sewn anastomosis in 2003.In his study,the Albert-Lembert method was used for the laparoscopic hand-sewing procedure and the anastomosis time was 90 min.Due to the complexity of the procedure and large amount of time required for anastomosis,it seemed that the hand-sewn anastomosis was not widely performed.

After almost 10 years,Matsuo et al.[7]reported another study about hand-sewn B-I anastomosis.They performed hand-sewn gastroduodenal anastomosis in 18 cases.The mean time of B-I anastomosis was 64.6 min.Matsuoet al.[7]described that 3-0 absorbing thread was placed in the lesser curvature as a supporting thread.A seromyotomy of the stomach was performed at the posterior wall.Both the remmant stomach and the duodenum's seromuscular layer were discontinuously sutured by extracorporeal knottyping method.The lumen was opened with the stomach and the duodenum in a fixed status.The thread of the anchor suture was lifted upward to the abdominal wall.After that all layers of the stomach and the duodenum at the posterior wall were continuously sutured.The authors believed that hand-sewn anastomosis had some advantages.Hand-sewn sutures were not affected by the degree of freedom of the duodenum.Because staplers were not used,the anastomosis area was soft and highly flexible.The handsewn anastomosis was economical due to that less staplers were used.

CIRCULAR STAPLER USED IN INTRACORPOREAL B-I RECONSTRUCTION

In the open surgery,circular stapler is well applied as a standardized reconstruction method of gastroduodenostomy.However,when it was attempted laparoscopically,the situation was often the opposite.

Uyamaet al.[8]firstly described intracorporeal B-I reconstruction using a circular stapling device and introduced one case in 1995.The method was defined by the same anatomic parameters as for the open B-I.After that,Moriyaet al.[9]and Mayers and Orebaugh[10]also reported B-I gastroduodenostomy with a circular stapler device.Both techniques were complicated and difficult to operate,and especially at the left subcostal area where an extended incision was needed.The extra incision spoiled the merit of minimally invasive surgery.

There are 2 major difficulties when circular stapler is applied in laparoscopic gastroduodenostomy.the first is the lack of a safe and fast intracorporeal purse-string suture technique and the second is the difficulty in manipulating the stapler and the stomach in a narrow abdominal cavity.In order to enable the anvil placement into the dudenum,many strategies were applied,such as a triple stapling procedure[8]and the use of the natural pyloric ring with endo-looping of the duodenum[9].Some techniques usually used in esophagoenteral anastomosis were also reported,such as using specially modified laparoscopic pursestring instrument[11]and opening the lumen and applying manual purse-string suture[12].However,there are still many difficulties to be overcome.

Kimet al.[13]reported a method which seemed to be quick and economical.The atraumatic clamps were used to prevent slippage of the duodenum which was cut with ultrasonic shear instead of linear stapler.After that,a seromuscular suture was done around the duodenal outer layer along the clamp.Omoriel al.[14]reported a method like reverse puncture technique used in total gastrectomy.The anvil secured with vicryl suture was inserted into the duodenum through semicircumferential duodenotomy.The needle was advanced to the anterior duodenal wall and then the duodenum was staple-transected.Finally,the center rod penetrated the duodenal wall.In this method the need for purse-string suture placement was totally eliminated.

Although the skill inserting anvil head in the duodenal stump can be improved,laparoscopically inserting the circular stapler into the remnant stomach was not always easy.After removing two-thirds to threequarters of the stomach,the small remnant stomach was usually so small that it was difficult to insert the stapler,even from the epigastric region.Sometime it was very difficult to form a straight line among the duodenum,remnant stomach and the circular stapler from the umbilical wound.Omoriel al.[15]described a novel method to insert the circular stapler to connect the anvil head.Firstly,the anvil head was passed through the posterior gastric wall with laparoscopic endloop,which can make the duodenum and remnant stomach form a straight line.Secondly anterior gastric suture was used to exteriorize the anvil shaft partly from the gastrotomy.And then the anvil shaft was advanced into the remnant stomach to make the anvil and the stapler join tighter.

LINEAR STAPLER INTRACORPOREAL B-I RECONSTRUCTION

Delta-shaped anastomosis and modified delta-shaped anastomosis

With the development of laparoscopic instruments and the continuous accumulation of surgical experience in recent years,linear stapler intracorporeal gastrointestinal anastomosis techniques have been developed.Kanayaet al.[16]firstly reported a anastomosis method which used only laparoscopic linear staplers in the hope of overcoming the drawbacks of extracorporeal reconstruction.The method named delta-shaped anastomosis (DA) was a modified intracorporeal B-I reconstruction which was soon promoted.The emergence of the DA method made intracorporeal gastroduodenostomy possible,which greatly promoted the development of totally laparoscopic distal gastrectomy (TLDG).Utilization DA method allows gastroduodenal anastomosis with a diameter of at least 30 mm while avoiding stricture.Kanayaet al.[17]analyzed the result of initial 100 procedures and showed that the mean time of the anastomosis was 13 min and the rate of anastomosis related complications was rare in 2011.

But some surgeons worry about the blood supply affected during cutting,which would result in leakages ranging from 0.42% to 8.5%[17-20]and anatomical distortion which exist in twisting around the anastomosis[21].In order to overcome the twisting around the anastomosis,some modified delta-shaped techniques were studied.

Huanget al.[22]reported modified DA in 2014.This was different from the conventional DA in closing the common stab incision of stomach and duodenum.In order to avoid the poor blood supply of the duodenum,the duodenal cutting was totally resected.The appearance of the anastomoses was changed from two intersections to only one as an inverted T-shape,which could decrease the anastomotic weak point.They reported comparable postoperative outcomes and showed that modified DA was technically safe and feasible[23]in another study.

After DA,many surgeons develop many other anastomosis methods based on linear stapler.

Triangulating stapling technique

Tanimuraet al.[24]described the triangulating stapling technique based on a linear stapling device in 2008.The mean anastomotic time was 35 min.In this method,the duodenum can be transected in any direction,and by forming a triangle,the anastomosis lumen is made wide with no ischemic areas.Both stumps of duodenum and remnant stomach were opened fitting their caliber,the gastroduodenostomy linear stapler in the posterior wall and 2 everted sutures in the anterior wall with linear staplers.Before each direction anastomosis,both duodenum and remnant stomach were elevated ventrally with 3 stay sutures.But there are still some problems about this method.There were some differences between the stomach and duodenum in terms of lumen size,wall thickness,and wall extensibility.The first introverted anastomosis,which forms the base of the triangle,was cumbersome once all of the staple lines on the stomach and duodenum had been cut off.

Book-binding technique

Ikedael al.[25]described the book-binding technique using linear stapler in 2012.The mean anastomotic time was 34 min.In their method,the duodenum was transected form the greater curvature side to the lesser curvature side.Small openings are made in the remnant stomach and duodenal stumps just wide enough to insert one of the jaws of the linear stapler.After the first stapling,there were three staple lines including those from the transection of the stomach and duodenum,which ran in parallel to the anterior wall.To prevent the formation of ischemic areas,a large opening was created on the anterior wall by transecting the entire duodenal stump and one-third of the gastric stump together with the anterior wall of the first anastomosis line.The anterior hole was then fired by linear stapler twice to close the large opening.Because a large opening was created on the anterior wall by transecting tissue and anastomosis line,maybe some tension was generated after the anterior hole was closed by the linear stapler.Further studies need to be done.

Linear-shaped gastroduodenostomy

Byunet al.[26]developed a linear-shaper gastroduodenostomy method by which the appearance of anastomosis was completed inverted T-shaped in 2009.Duodenum was transected from the greater curvature side to less side.One incision was done in the greater curvature of remnant stomach at the point 60 mm apart from the resected line.The other incision was done on the superior edge of the duodenal transection line.After creating the c anastomosis lumen,the common entry incision was closed by laparoscopic linear staplers.Finally,the greater curvature of stomach and the antero-superior of duodenum were perpendicular.By using this method,the rotation duodenum and remnant stomach was not needed which can reduce the risk of poor vascular supply.In their study,there were less bile reflux,gastritis degree and residual food grade compared to DA anastomosis in 6 months after surgery.

Augmented rectangle technique

In our group,we developed a method named augmented rectangle technique (ART) anastomosis.Three automatic laparoscopic linear staplers were used to create the gastroduodenostomy and the anastomotic opening was wide and less likely to become stenosed or twisted[27].This method was easy and time-saving.We performed 160 LDG operations using this technique from December 2013 to August 2017.There were no postoperative complications associated with the reconstruction,such as anastomotic leakage,hemorrhage or stenosis.In the ART method,the duodenum was transected form the greater curvature side to less side.Small incisions were made in duodenal stumps and the greater curvature of remnant stomach in order to insert the jaws of the linear stapler.After inserting the stapler,the lesser curvatureend of the duodenal stump was rotated externally by 90°.After the initial suturing between the remnant stomach and the duodenum,the two sides (posterior wall and cranial wall),the posterior wall and caudal wall,form a V-shape.A 30 mm linear stapler was applied to close the insertion holes up to the closest side of the duodenal resection margin.After gastric and duodenal resection margins were ensured to be close together,the 60 mm laparoscopic linear stapler was used to transect the duodenal resection margin to create the margin.After the above steps,all the previous linear staplers were removed from duodenal resection margin.

Table 1.Summary of different methods applied in intracorporeal Billroth-I reconstruction

Thanks to the elimination of the stay sutures in the anastomosis site,the risk of leakage of the intestinal contents into the peritoneal cavity can be reduced with a result of reduced incidence of peritoneal abscess[28,29].Removing the staple line of the duodenal stump without creating a T-shaped anastomotic region can avoid postoperative stenosis.The ART can create larger 4-sided anastomosis diameters than 3-sided ones,without worrying about whether the width of the opening will be reduced by the final stapling.

APPLICATION OF BARBED SUTURE IN INTRACORPOREAL ANASTOMOSES

Intracorporeal suturing and knot typing in some B-I anastomosis were time-consuming and tedious and especially these procedures were the last steps to do in LDG.But various devices have been developed to simplify the placement of intracorporeal sutures,and barbed suture is one such device.Using the barber suture could reduce the number of knot typing,the suturing efficiency and reduce the cost of intracorporeal reconstruction with staplers[30].Leeet al.[30]used barber sutures to close entry hole in 354 patients instead of staplers with a result of minimizing the suturing time.There were no patients who needed to be converted to usual sutures or mechanical closure with staplers and only one patient presented with postoperative anastomotic bleeding.

CONCLUSION

Several reconstruction techniques are possible after TLDG [Table 1].The best reconstruction is the one,that simplifies the technique,maintains satisfactory nutritional status and quality of life while keeping postoperative morbidity as low as possible.We believe that the new technologies and improved techniques will bring more benefits to patients and doctors.

DECLARATIONS

Authors' contributions

Study's conception and design.Zhang S,Fukunaga T

Writing the paper.Zhang S

Provided administrative,technical,and material support.Fukunaga T

Availability of data and materials

Not applicable.

Financial support and sponsorship

The study was supported part by Japan China Sasakawa Medical Fellowship.

Conflicts of interest

All authors declared that there are no conflicts of interest.

Ethical approval and consent to participate

Not applicable.

Consent for publication

Not applicable.

Copyright

© The Author(s) 2019.