目录
- Investigation on surface integrity of electron beam melted Ti-6Al-4 V by precision grinding and electropolishing
- Microstructural characterization and mechanical behavior analysis of 7075-T6 aluminum subjected to simulated lightning strikes
- Parameters for evaluating the efficiency of inlet compression
- A novel model-based multivariable framework for aircraft gas turbine engine limit protection control
- Statistical characteristics of spray autoignition of transient kerosene jet in cross flow
- Diagnostic and modelling investigation on the ion acceleration and plasma throttling effects in a dualemitter hollow cathode micro-thruster
- Entropy based inverse design of aircraft mission success space in system-of-systems confrontation
- Nonlinear resonance characteristics of a dual-rotor system with a local defect on the inner ring of the inter-shaft bearing
- Failure mechanisms of bolted flanges in aero-engine casings subjected to impact loading
- Dynamic parametric modeling-based model updating strategy of aeroengine casings
- Synchronized perturbation elimination and DOA estimation via signal selection mechanism and parallel deep capsule networks in multipath environment
- Improving seeking precision by utilizing ghost imaging in a semi-active quadrant detection seeker
- A high dynamics algorithm based on steepest ascent method for GNSS receiver
- Relevant experience learning:A deep reinforcement learning method for UAV autonomous motion planning in complex unknown environments
- Wetting behavior of AgCu-4.5Ti filler reinforced by carbon nanotubes on C/C composite
- A mask R-CNN based method for inspecting cable brackets in aircraft
- Multiaxial fatigue life prediction of composite laminates
- Effects of traverse speed on weld formation,microstructure and mechanical properties of ZK60 Mg alloy joint by bobbin tool friction stir welding
- Improvement of machining accuracy in EDCM by enhanced electrochemical reaming based on a non-metallic backing layer
- Principles and methods for determining calendar life and corrosion tolerance of mechanical parts
- RANS simulations on combustion and emission characteristics of a premixed NH3/H2 swirling flame with reduced chemical kinetic model